14
b) Beginner mode
There are two modes, normal and beginner. Beginner mode is designed for novice model users. The throttle response
will be reduced by 50% making the model easier to control.
• To enter beginner mode: Press and hold the CH4 button and the steering wheel all the way counter-clockwise, and
then switch the transmitter POWER ON.
- The G.LED will flash to indicate you are in beginner mode.
- The mode will be saved after powering off.
• To exit beginner mode: Press and hold the CH4 button and the steering wheel all the way counter-clockwise, and
then switch the transmitter POWER ON.
- The G.LED will not light up
- The active mode will be saved after powering off.
c) Channel reverse
These switches are used to reverse the direction of movement in relation to the input.
• ST.REV: Reverses CH1 (steering input).
• TH.REV: Reverses CH2 (throttle input).
d) Fail-safe (safety mechanism)
Important
• The fail-safe determines what the receiver will do if it loses the signal from the transmitter, and includes
the servo position.
• If no fail-safe has been set, the receiver will not output any signals when the connection is lost.
1. Switch the transmitter POWER ON and check that it is bound to the receiver.
- Receiver: The G.LED will flash slowly.
- Transmitter: The LED will be solid on.
2. Hold the steering wheel and throttle lever at the desired failsafe position, for example:
- Steering wheel: Neutral "Hands off" position.
- Throttle lever: Neutral "Hands off" position.
3. Press and hold the BIND button for three seconds, the G.LED will flash every 2 seconds to indicate that the fail-
safe has been set.