41
12. Inserting and Connecting the Flight Battery
Caution, important!
Before connecting the flight battery to the model, the remote control transmitter must be taken into operati
-
on. Observe that the transmitter is set to the mode desired by you and the control lever for the motor function
is in the bottom position.
Connect the flight battery (1) with the connector protected against polarity reversal (2) of the model electronics. Then
connect the rechargeable battery to the front position of the battery chute (3).
After approx. 2 seconds, a red LED lights up on the model electronics and signals readiness for operation of the
model.
The rudder and elevator, as well as the motor react to the movements of the control levers at the transmitter now.
If the LED is not lit, the transmitter may not be switched on or not be recognised by the receiver (see chapter
13 on this).
If the LED flashes slowly, either the control lever for the motor function is not correctly pushed to the bottom
position or the throttle function trimming is set too high.
Figure 7
