REED 00 C50SS, Manual, Page: 43 / 84

REED
00 MODEL:
C50SS
TRAILER CONCRETE PUMP
MAINT
PAGE 13
•
Start up machine and observe for leakage.
DO NOT ATTEMPT TO WASH OUT FILTER ELEMENT.
These are disposable types and more harm can be
done than it is worth.
CLEANING THE HYDRAULIC TANK
The hydraulic tank should be drained and cleaned after 1000 hours of operation or yearly
whichever comes first. This will assist in keeping the systems clean and in proper condition.
To accomplish this the following is offered.
•
Shut off machine. On pump circuit allow accumulator system to depressurize
Place a suitable size container under the hydraulic tank drain fitting located at back of
tank facing the hopper.
NOTE: The tank has a capacity of 60gals (227 L). Make sure
your drain container is large enough. Remove drain plug.
•
Remove the access cover on the hydraulic tank being careful not to damage the
gasket
•
Remove the two (2) suction strainers
•
After tank has drained, flush the inside of the hydraulic tank with clean solvent and
wipe clean with lint free cloths. DO NOT USE PAPER TOWELS . Remove any
particles from tank bottom and sump
•
Clean the suction strainers by soaking them in fresh solvent and then air blow dry
•
Install the tank drain plug. Reinstall the suction strainers and access cover with gasket
•
Clean the filler breather with solvent and air blow dry
•
Change the hydraulic system filter element
•
Refill the hydraulic tank with new CLEAN hydraulic fluid, SHELL TELLUS 46
•
Start machine and check for leaks
REVISION: