STRONG DESIGNS RW EDGE 540V3 30CC
17
Fuel Tank
•The fuel tank comes pre-assembled, remove
the stopper and verify everything is correct.
•The fuel tank utilizes a 3-line setup and is
configured as shown above inside the tank.
From the Pro:
Mark the
top of the fuel tank and
label or color code the lines
to avoid confusion after
you secure the assembly
into the fuel tank.
•Tighten the stopper into the tank. Then secure
into the fuselage using the straps provided and
route the fuel lines.
Cowl Installation
•First make templates for each cut-out of the
cowl – typical muffler
tube templates
shown.
•Once you have templates made for each of the
cutouts, tape them in place on the fuse to
properly locate the
cowl cutout.
•Next, remove all items that require a cutout
and install the cowl. – this may mean removing
the engine or muffler(s) again.
NOTE:
The cowl ring should be fully seated on
the fuselage and will properly align the cowl.
From the Pro:
Use masking
tape on all areas to be
marked on the cowl. This
allows you to easily see the
lines making for a cleaner
cutout.
