STRONG DESIGNS RW EDGE 540V3 30CC
4
•Locate the servo pocket and remove the
covering. Then drop the servo into place and
drill for the servo screws with a 1/16” drill bit.
From the Pro:
When removing the covering leave
1/8-1/4” of covering to be ironed down into the
servo pocket. This makes for a much cleaner and
more fuel-proof servo cut-out.
•Remove the servo and thread a servo screw in
and out of each hole. Then apply 2 drops of thin
CA to each and allow the CA to soak in and fully
cure.
•Install the servo with the output to the leading
edge, pulling the wire lead out to the root of
the wing.
•Center the servo and install the servo horn
pointing toward the wingtip, aligning with the
control horn.
•Assemble the control rods to 3.25” length
making sure the turnbuckle is centered with
room to adjust both ends.
• Install the pushrod using the included
hardware.
From the Pro:
It is best practice to use a small
washer on the outside of the ball link on the servo.
This will prevent the ball joint
from slipping off under load.
