Red
MAX
™
Base Station
user manual
Doc. #70-00058-01-01-DRAFT
Proprietary Redline Communications © 2006
November
29,
2006
Page 35 of 106
4.2.2 Status
Click
Status
in the system menu (left side of screen) to view status information about the
wireless interface and Ethernet management interface. Values are updated according to
the screen refresh rate.
Figure 15: Web - Monitoring - Status - Wireless Status Screen
Wireless Status
CINR dB
: Mean Carrier/(Interf Noise) ratio. The CINR value is calculated and
displayed for each automatic screen refresh. The CINR measured by the base station is
based on the signal from the subscriber. Based on this value, the base station may request
that the subscriber change modulation rate.
RF Tx Power dBm
: Radio transmission output power level.
Traffic Downlink Kbps
: Rate of traffic transmitted to subscribers.
Traffic Uplink Kbps
: Rate of traffic received from subscribers.
BW Margin Downlink Kbps
: Downlink bandwidth available that can be scheduled by
the base station.
BW Margin Uplink Kbps
: Uplink bandwidth available that can be scheduled by the
base station.
CRC Errors
: Number of CRC errors detected on packets received from subscribers. This
counter is reset when an base station is rebooted.
Note: The CRC Errors counter in the SS Info screen is reset when a subscriber is
registered.
Registered SS's
: Number of subscribers currently registered with the base station.
Air Interface Status
: Status of the base station transceiver:
Enabled
- Transceiver is operating normally.
Disabled
- Transceiver is disconnected, disabled, or defective.