Redline Communications AN-50, User Manual

Page: 48 / 76

AN-50 System User Manual
Redline Communications …..solving the first mile challenge .
9.1.2. System Fault
If the
Fault LED illuminates solid red, it is an indication that there
is a serious problem with the system software or hardware.
Check the IF cable. A short or long reset may fix the problem. If
not, contact your local Redline representative. Also refer to the
RF Status codes, as well as the System Logs.
9.1.3. Wireless Link
Link – For a slave terminal, the “Link” LED lights solid green when the
radio link to the master terminal is established and the LED will turn off
if the link is lost. For a master terminal, the LED lights solid green
when at least one radio link to any of the provisioned slaves is
established and will turn off if all links are lost.
The Wireless Link LED illuminates solid green when the wireless link is established to
the remote terminal. When the Link LED is off, it is an indication there is a problem with
either the terminal link, radio, or with the actual propagation path itself. Check the RF
Status parameters in the System Status screen. The table below lists some of the
potential causes:
Table 4: Wireless Link Diagnostics
Symptom Possible Problem Solution
Remote terminal is not on or is
malfunctioning. Verify operation of remote
terminal.
The propagation path is
blocked. Clear path or re-locate antennas.
The transceiver is mal-
functioning. Repair or replace transceiver
Antenna has moved and is no
longer aligned with remote
terminal. Re-align the antenna.
Cable between transceiver and
antenna or between transceiver
and terminal not properly
connected. Properly secure cables.
No wireless link
(Link LED does
not illuminate)
Power not getting to the
transceiver from the terminal. Repair or replace terminal.
Receiver and transmitter have
been set to different RF
channels. Make sure both units are
operating on the same RF
channel.
Page 48 of 76