25
12.4 Adjusting the shock absorber
The length of the shock absorber is very important for the proper operation of the machine. This length
must be minimum 476 mm (18.74”). If the length is larger, the machine could get damaged.
Calibrate the shock absorber as follows (see Figure 15):
1. Unscrew the nut
(2)
.
2. Rotate the large ring
(1)
until the required length is achieved.
3. Tighten the nut
(2)
again.
If the required length cannot be achieved, then most likely the rubber buffer (3) has
worn out and should be replaced.
Figure 15
12.5 Checking the oil level in the gearbox
The machine has a gearbox centrally located at the rear side of the machine. Do the following for
checking the oil level in the gearbox (see Figure 16):
Figure 16
1. Make sure that the machine is horizontal.
2. Unscrew the bolts
(1)
and open the rear cover.
3. Check the oil level by removing the screw
(2)
.
4. The gearbox should be filled up to the bottom of the screw hole, the level line
(3)
.
5. If necessary, top up the oil in the gearbox up to the level line
(3)
using 80W90 GL5 oil.
6. Mount the screw
(2)
and tighten it.
7. Close the rear cover and screw the bolts
(1)
tightly.
Summary of Contents for Verti-Drain 2519
Page 28: ...28 Figure 18...