Redexim Verti-Drain 2519, User Manual And Parts Book, Page: 13 / 31

13
3. Attach the lifting arms (2) to the machine using the 3-point pins. Lock the pins using
the R-clips.
4. Set the stabilizer of the lifting arms (2) to 100 mm lateral stroke.
5. Mount the top rod (3) onto the tractor and attach it to the machine.
6. Connect the PTO ( 4 ) between the machine and the tractor. Slip coupling at the
machine side.
7. Place the required pins in the pin holders (5) , if these are not mounted yet.
Make sure that the 3-point pins are locked using the R-clips!
8. Start the tractor and lift the machine.
!! Switch off the tractor’s engine and PTO before descending !!
!! Make sure that the tractor and machine cannot move uncontrolled !!
9. Remove the adjustable legs (6) by removing the pins (7) and place them on the
machine (8) .
Secure the tension rubber or clips.
10. Set the rear roller in the terrain-following position by removing the pin (10) and placing
this pin in the rear hole (12) . Secure using the R-clip.
11. Adjust the top rod so that the machine is at the working depth that you want to use
and it is horizontal in relation to the ground. Use a spirit level (9) as reference for this
work activity.
7.2 Detaching the machine
The machine should be detached in the following manner (
see Figure 5):
1. Fix the rear roller by inserting the pin (10) into the hole (11) in the correct position.
Secure using the R-clip.
Make sure that the rear roller is horizontal, so that the machine is supported straight on the
adjustable legs.
Make sure that the machine and the tractor cannot move while you are detaching them!
Switch off the tractor engine
before
detaching the machine!
2. Place the adjustable legs (6) and attach them to the machine using the pins (7) .
3. Secure the pins using the locking clips.
Check whether the adjustable legs are mounted in the correct holes to prevent
damaging the pins and/or machine.
4. Carefully place the machine on the ground.
Check again whether the machine is stable on the ground.
5. Loosen the top rod (3) and remove it.
6. Detach the lifting arms (2) from the machine.
7. Detach the PTO (4) at the tractor side.
8. Start the tractor and drive off.