12
- Remove the brush roller by loosening the screws (2).
- Release the tension on the conveyor belt on both sides (3).
- Remove the bearing on the right seen in the direction of travel (4).
- Pull away the side element (5) with tension bearing (6).
- Remove the conveyor belt.
The reassembly takes place in reverse order.
Stretching conveyor belt after assembly
- Tension the conveyor belt on both sides evenly using the two tension screws
until the marked length is stretched to 487 mm [19.17”](distance between centres).
- Allow the conveyor belt to run in for approx. 30 minutes until it runs centrally.
The conveyor belt should not graze the sides. If readjustment is
necessary increase tension on the side which is doing the grazing.
Too much tension will reduce the life span of the conveyor belt.
REPAIR AND MAINTENANCE
External hydraulic unit
#
Oil change for the hydraulic pump (every 100 operating hours)
- Unscrew filler screw (1).
- Loosen drain plug (2) and drain off oil.
- Screw on drain plug with new gasket.
