2 SPEED GEARBOX
User manual
Ref.: RX142/046
Version 09/05/2017 - English
This document must not be reproduced nor information therein disclosed without our authorization
Page 24 / 35
-
Case of application
If the pinion is supported by an additional bearing made by the customer
(Exceptionally it can be used without, but it should be carefully checked with REDEX)
-
Mounting procedure:
A.
Control the shaft dimensions and geometry; it must be fully compliant with the above table
B.
Clean all the surfaces of bore and shaft
C.
To minimize fretting corrosion between shaft and bore, we recommend using a grease type
KLÜBERPAST46-MR
–401 on bore and shaft surfaces.
D.
Put the shaft into the bore. Ensure good coaxiality and slightly oscillate the shaft in order to
engage properly the splines.
E.
Tight the screw with the right torque
F.
Control the run-out of the pinion with the centering diameter (chapter 5.3)
Screw type
(Class 12.9)
Tightening
torque (N.m)
M16
355
M20
690
Summary of Contents for MSR 330
Page 39: ......
