2 SPEED GEARBOX
User manual
Ref.: RX142/046
Version 09/05/2017 - English
This document must not be reproduced nor information therein disclosed without our authorization
Page 25 / 35
5.2 Tight mounting
Ø B
E2
Ø C
D
L
MSR330
63k6
60x2x28-6p
55h6
45
112
MSR640
83k6
80x3x25-6p
70h6
65
151
MSR650
100k6
95x3x30-6p
85h6
65
151
MSR660
-
-
-
-
-
-
Mounting procedure:
A.
Control the shaft dimensions and geometry; it must be fully compliant with the above table
B.
Clean all the surfaces of bore and shaft
C.
To minimize fretting corrosion between shaft and bore, we recommend using a grease type
KLÜBERPAST46-MR
–401 on bore and shaft surfaces.
D.
Cool down the shaft with liquid NITROGEN.
G.
Put the shaft into the bore. Ensure good coaxiality and slightly oscillate the shaft in order to
engage properly the splines.
E.
Control the run-out of the pinion with the centering diameter (chapter 5.3)
WARNING!
Take extreme care when manipulating liquid nitrogen. Always wear
appropriate gloves and glass. It may cause severe injury in case of
contact with human body.
Summary of Contents for MSR 330
Page 39: ......
