2 SPEED GEARBOX
User manual
Ref.: RX142/046
Version 09/05/2017 - English
This document must not be reproduced nor information therein disclosed without our authorization
Page 12 / 35
N.
To validate the assembly of the sun gear, re-measure the shaft radial run-out tolerances as
indicated on pictures below.
O.
Proceed to the motor mounting (see
chapter 3.3
)
3.2.4 "F" input flange code (input sun gear with seal, with bearing)
MSRXXX .
F
H 5 S . 2076 M2 . 21J42 . D . SS
A.
Put the motor horizontally on a table
B.
Clean and degrease the motor shaft
C.
Adjust the key to the input sun gear keyway and to the motor shaft keyway
D.
Fit the key on the shaft
E.
Lightly grease the motor shaft using an anti-fretting paste
F.
Proceed to the motor mounting (see
chapter 3.3
)
Shaft diameter
d
(mm)
Radial run-out (mm)
Shaft radial run-out measurement
Summary of Contents for MSR 330
Page 39: ......
