RED DSMC, Operation Manual, Page: 23 / 58

DSMC POWER OPERATION GUIDE
COPYRIGHT © 2013 RED.COM, INC 955-0038, REV-A | 23
MOUNT THE REDVOLT XL MODULE
The REDVOLT XL MODULE can be installed directly to the DSMC BRAIN, or attached to another module using
the quicklock mechanism. Engineered with a unique and flexible Switch Plate that can be reversed for the pre-
ferred mounting using a T10 Torx driver and built in captive screws, the REDVOLT XL MODULE is a convenient
and low profile power solution.
Use the following instructions to change the Switch Plate for flexible mounting:
1. Use a T10 Torx driver to loosen the six black screws on the Switch Plate (M3x0.5 x 8mm).
2. Remove all six (6) screws fastening the Switch Plate to the REDVOLT XL MODULE.
3. Reverse the Switch Plate to the desired mounting configuration.
4. Align the Switch Plate on the REDVOLT XL MODULE.
5. Insert and tighten the six black mounting screws in a cross pattern. DO NOT FULLY TIGHTEN.
6. Fully tighten the screws in a cross pattern. DO NOT OVERTIGHTEN.
For more information on installation with the Switch Plate, check out the
REDVOLT XL MODULE Installation
Video on our website at http://www.red.com/store/products/redvolt-xl-module .
INSTALL THE REDVOLT XL MODULE
The REDVOLT XL MODULE installs directly to the DSMC BRAIN in the same way the MODULE ADAPTOR and +1
ADAPTOR MODULE are installed. For more information, go to “Install the MODULE ADAPTOR” on page 13 .
ATTACH THE REDVOLT XL MODULE
The REDVOLT XL MODULE attaches to other adaptors and modules in the same way other DSMC modules at-
tach. For more information, go to “Attach DSMC Modules” on page 18 .
REDVOLT XL MODULE Switch
Plate