COPYRIGHT © 2013 RED.COM, INC
DSMC POWER OPERATION GUIDE
955-0038, REV-A | 18
ATTACH DSMC MODULES
These instructions are applicable to all DSMC modules. The PRO BATTERY MODULE (QUAD) is shown in these
instructions.
Use these instructions to attach any of the DSMC modules.
WARNING:
DSMC modules and adaptors are NOT HOT SWAPPABLE, meaning you cannot remove or install the
modules while the camera is powered on. Before installing or removing modules, you MUST power down the
camera. Failure to do so may result in damage to the modules or DSMC that will not be covered under warranty.
WARNING:
Most DSMC modules require a MODULE ADAPTOR or +1 ADAPTOR MODULE for attachment to
the DSMC BRAIN. These modules are sold separately from the DSMC modules. The REDVOLT XL MODULE is
equipped with a reversible switch plate and can be installed with or without an adaptor.
REQUIRED TOOL:
T20 Torx driver
1. Insert the lip at the top of the module into the recess at the top of the MODULE ADAPTOR.
2. Rotate the module down flush with the rear of the MODULE ADAPTOR.
3. While applying steady pressure to hold the module against the MODULE ADAPTOR, use a T20 Torx driver
to rotate the MODULE ADAPTOR locking mechanism clockwise to the “Lock” position in order to secure
the module.
Insert Module Lip
Press Module Flush