
DSMC POWER OPERATION GUIDE
COPYRIGHT © 2013 RED.COM, INC
955-0038, REV-A | 15
INSTALL THE +1 ADAPTOR MODULE
Use the instructions in this section to install the +1 ADAPTOR MODULE.
WARNING:
DSMC modules and adaptors are NOT HOT SWAPPABLE, meaning you cannot remove or install the
modules while the camera is powered on. Before installing or removing modules, you MUST power down the
camera. Failure to do so may result in damage to the modules or DSMC that will not be covered under warranty.
REQUIRED TOOL:
T20 Torx driver
1. Power down the camera.
2. Remove the REDMOTE, if attached.
3. Align the +1 ADAPTOR MODULE with the back of the DSMC BRAIN.
4. Insert the HDMI connector into the DSMC BRAIN.
I1 ADAPTOR MODULE
Insert the HDMI Connector to
DSMC BRAIN