CONTROL
To adjust the input, pre-amplifier, and headphone settings, select
Control
.
CHANNEL 1/2 AND CHANNEL 3/4
To set up Channel 1/2 and 3/4, go to
Menu
>
Settings
>
Audio
>
Control
.
Figure: Channel Setup
SOURCE
SOURCE NAME
CHANNEL PAIRS
CONNECTORS
None
N/A
N/A
Camera Internal
Ch1/Ch2, Ch3/Ch4
Mic 1, Mic 2
Rear Analog
Ch1/Ch2, Ch3/Ch4
AUDIO (full-size XLR)
NAME
You can rename each audio channel. The default names are Ch1, Ch2, Ch3, and Ch4. The channel names display in
the Audio Meter, but are not included in the clip metadata.
MODE
When Rear Analog is selected, the Mode (Line, Mic, or +48V) displays for the incoming audio signal.
PHANTOM POWER
The 5-pin XLR connector pr48 V phantom phantom power.
Enable phantom power (via the switch adjacent to the XLR port) after a microphone is connected. Disable phantom
power (by switching to Line or Mic) before removing the microphone.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D
|
1 4 4
RED RANGER OPERATION GUIDE
