Recognition Systems HandPunch 50E, Manual

Page: 35 / 58

HandPunch 50E Manual
Page 33
Calibrate The Calibrate command displays the HandPunch’s exposure values,
allowing you to verify these values are within normal operating
parameters. The standard operating parameters are shown in Table 5.
Status
Display The status display command allow you to enable or disable the
displaying of the following information.
• the status values of HandPunch inputs and outputs
• the hand read score of the last user to verify on the system
When the status display is enabled, Figure 8-1 identifies each status
display field value.
Figure 8-1 Status Display Chart
Table 5: Normal Operating Parameters
Parameter Normal Range
Row “r” 0 +/- 2
Column “c” 0 +/- 2
Exposure “e” 100 +/- 20
Last Hand Read Score
Aux Out 2
Aux Out 1
* Aux Out 0
* Lock
Aux In 2
Request to Exit
Aux In 1
Door Monitor Switch
Tamper
* These status values are inactive if the
reader is in Card Reader Output Mode.
O = Circuit Open H = Output is OFF (High)
C = Circuit Closed L = Output is ON (Low)
O C O C O H L H L NN
- ENTER ID -
O C O C O H L H L NN
These Input/Output
values do not apply to
the HandPunch 50E