Real Flame VEKTOR 1100, Installation & Operating Manual

Page: 50 / 56

50
INJECTOR AND PILOT REMOVAL INSTRUCTIONS
(continued)
22.
PILOT REFITMENT
Replace pilot orifice with correct gas type.
Refit pilot gas pipe to pilot assembly and tighten.
Place burner assembly into appliance.
Refit spark probe and gently tightly
Refit spark lead
Locate pilot assembly onto original position and refit the bracket retaining screws.
Note: Check all wires are sitting correctly, flush to front wall. Ensure spark lead is not
broken or excessively bent. Ensure lead hole is still sealed.
(High temperature silicon is suitable for resealing.)
23.
BURNER REFITMENT
Carefully place burner into firebox, screwing burner plate onto burner bracket.
Tighten gas and pilot pipe connections to the bulkhead fittings located at the bottom of the
firebox.
Ensure 2 spanners of correct size are used to prevent loosening of bulkhead nut.
Refit burner tube assembly, Tighten nuts (3 off )
Check burner location to pilot.
Pilot location to burner. – Burner should sit within 2mm of the pilot bracket. Burner must sit
on the pilot bracket support. Adjust if required.
Refit Media support tray (Mesh).