17
INSTALLATION
(continued)
Fixing the fire into the cavity
To fix the fire to the cavity, first drill 4 to 6 (5mm diameter) holes in the outer flange (as shaded
grey in the picture below) in locations which will give you the most support from the cavity
framework behind and evenly spaced around the flange. Using the supplied Stainless Steel
screws, fasten the fire to the cavity through these drilled holes.
Connecting the Gas Pipe
When the fire unit has been pushed into position and secured the flexible hose can be con-nected
to the inlet side of the appliance regulator at the front centre of the fire. The hose and pipe
assembly should have been tested prior to this.
No matter which connection the installer chooses, the regulator that is supplied in the fire MUST
NOT BE REMOVED. Removal of the regulator, or replacing it with one not intended for use with a
IO1000, will void the limited appliance warranty.
The IO1000 must be disconnected from the gas supply piping system during any pressure testing
of that system at test pressures in excess of ½ psi (3.5 kPa).
Ensure that the fire is securely located and free from movement.
Suggested location for screws of mounting:
Summary of Contents for EXURO IO1000
Page 22: ...ELECTRICAL SCHEMATIC 22...
Page 23: ...EXPLODED VIEW 23...
