RDC6585PC Control System manual
V1.0
SHENZHEN RUIDA TECHNOLOGY
40
At this point, the "blue selection block" defaults to select the "Mult origin enable" entry, press
the
<Enter>
key to enable or disable(the right small square shows red when enabled), when enabled,
the little finger to "Origin 1 enable" entry means to start setting the origin point 1, first move the
"blue selection block" to this entry and press the
<Enter>
key to enable the location point 1 entry,
then press
<Shift>
key, then press the direction key to change the X/Y axis coordinate value, then
press
<Origin>
key to set the current coordinate value to the location point 1, and finally press
<Shift>
key to return to the current interface operation. The operation process interface is as follows:
Other origins are set in the same way.
When the "Select Block" stops on the "Start origin" entry, press the
<Enter>
key to enter the
modification, press the "Up/Down" key to modify, after the modification, press the
<Enter>
key, the
parameters automatically take effect, and press the
<Esc>
key to return to the menu interface.
Each item introduced as below:
Figure 8.4.5-1
Figure 8.4.5-2
