JOINTLY DEVELOPED WITH
WWW.RC-WARBIRDS.COM
Page 5/16
Once all holes are drilled install both
retract unit and steering servo.
Install the included nose gear wire and
steering arm. Both items need to be
removed again later so do not tighten them
to much.
Cut 2x 40cm from the supplied pull-pull
cable and pull one through each of the
airtubes installed in the retract mount. Next
slide one of the supplied crimp rings over
the wire and loop the wire through the
steering arm. After that pull the end of the
pull-pull cable through the crimp ring a
second time.
For a stronger hold loop the end of the pull-
pull wire one more time from the front
through the crimp ring. Squeeze the crimp
ring together with pliers. Test that the wire
is firmly crimped in place by pulling on the
pull-pull wire behind the crimp ring.
Repeat this step with the second pull-pull
wire.
