JOINTLY DEVELOPED WITH
WWW.RC-WARBIRDS.COM
Page 11/16
Nose Retract Unit
The above cut out hast to be made for the nose retract unit.
Measure the center of the fuselage at the
height of the air intake.
Measure 1.5 cm (15mm) from the center
and 3cm (30mm) towards the tail of the
plane. Use 2 parallel masking tapes as
guide.
Measure and mark the cutout as shown
above and on the dimension drawing. For a
closer fit between retract wire and fuselage
it is possible to make the cutout smaller
and later enlarge it once the retract mount
has been installed.
Cut the marked area with a Dremel cutting
disk and drum sander. Sand round edges
where possible.
