JOINTLY DEVELOPED WITH
WWW.RC-WARBIRDS.COM
Page 13/16
Step 4: Final Installation
Before the air retracts can be installed the airtube needs to be measured and cut to length.
The following instructions are one example of how the airline can be installed.
Depending on your final setup and positioning of the battery and RC equipment you
might want to use a different method.
Install the nose steering servo and nose
gear wire.
Ensure that the gear wire or wheel does
not touch the fuselage during retract
operation as this might prevent the gear
from deploying later.
Test steering and retract operation.
If the retract does not lock in down
position reduce the pull-pull cable tension.
Cut the following length from the supplied
airline:
3x 20cm
1x 30cm
1x 10cm
Assemble the airline as shown.
Pull the airline inside the fuselage and
connect it to the retract units. Fix the retract
units in place with the screws supplied.
