Raytec Americas:
+1 613 270 9990 • [email protected]
Raytec Ltd reserve the right to change specifications without prior notification or public announcement.
Version 1
www.raytecled.com
1277-D
-0008
Installation Steps
Wall Mount Installation
Step 1.
Step 2.
Step 5.
Step 6.
Step 7.
Step 3.
Step 4.
This XR-WM kit is intended for use with UL Listed XR luminaire as marked on the luminaire nameplate.
Accessory Package Contents
Refer to alternate instructions if using Conduit, Hook, Pole or Yoke Mount
Inspect shipping package and contents to ensure no damage has occurred during
shipping.
Install provided 3/4 NPT conduit plugs in desired locations on wall mount. To maintain
ingress rating all NPT entries not used for wiring connections are required to be
plugged. Torque to 10 Nm (88 in-lbs)
NOTE: To aid in assembly and protection against ingress use of a petrolatum or soap
thickened mineral oil based thread lubricant/sealant is necessary.
Un-used conduit opening must be plugged to maintain the integrity of the enclosure.
Install Back Cover Plate with 4x M4 Flat head screws and adhesive backed gasket.
Apply gasket with adhesive side applied to mount main body. Torque to 1.7 N-m (15
in-lbs).
Mount luminaire assembly to desired location using 4x 1/4-20 OR M6 Screws or Bolts
(Not Provided).
Resume installation instructions provided with luminaire. (STEP 4 in XR Installation
Instructions from the Surface/Ceiling Mount installation provided with Luminaire).
Install provided 3/4” NPT plastic bushing onto side NPT entry on XR head, rotate
so that flats are parallel to lens surface to avoid interference with mount hardware.
Install Wall Mount main body with included M6 bolts and washers and adhesive backed
gasket. Apply gasket to mount with adhesive backed side. Torque to 5 Nm (45 in-lbs).
SPX-BKT-XR-WM
QTY
PART NAME
1
WALL MOUNT
1
WALL MOUNT PLATE
1
WALL MOUNT PLATE SIDE GASKET
1
WALL MOUNT GASKET
4
6 x 25mm SOCKET HEAD CAP SCREW
4
M4x 10mm FLAT HEAD SOCKET CAP SCREW
4
M6 FLAT WASHER
3
3/4 NPT HEX CAP PLUG
1
3/4 NPT THREADED SMOOTH BORE BUSHING
Steps 2 through 5
Step 6
[5.7in]
145mm
4 x 6.8mm THRU ALL
[5.7in]
145mm
SPZ-XR
!
Warning
Attention:
Le luminaire XR ne doit pas être orienté vers le haut à un degré
quelconque audelà de la position horizontale pour les installations
en zones dangereuses de classe II, division 2, zone 22 et classe III.
Warning:
The XR head must not face upwards any degree beyond the
horizontal position for Class II, Division 2, Zone 22 and Class III
hazardous location installations.
LIGHT
BEAM
HORIZON
