Raytec Americas:
+1 613 270 9990 • [email protected]
Raytec Ltd reserve the right to change specifications without prior notification or public announcement.
Version 1
www.raytecled.com
1277-D
-0008
5.0in
126mm
5.2in
132mm
16.0in
405mm
17.3in
441mm
0.5in
12.7mm
0.3in
6.8mm
0.5in
12.7mm
0.5in
12.7mm
0.5in
12.7mm
0.5in
12.7mm
Surface/Ceiling Mount Installation (Ordered Separately)
Step 1.
Step 2.
Step 3.
Warning
!
!
!
Warning
Warning
(Brackets are ordered separately)
Refer to alternate instructions if using Conduit, Hook, Wall, Pole or Yoke Mount
Inspect shipping package and contents to ensure no
damage has occurred during shipping.
Install Surface/Suspension Mount Brackets using the 8x
M6 hex cap bracket mounting screws. See diagram for
orientation of brackets. Torque M6 bolts to 5 Nm (45 in-
lbs).
A) For surface mounting configuration, mount luminaire
in desired locations using 4x 1/4-20 OR 4x M6 fasteners
and washers (Not provided). One mounting hole on each
bracket is keyed to allow partial pre-installation of two
fasteners for ease of install.
B) For ceiling mounting configurations, connect 4x
anchors to the 12.7mm (0.5”) holes. Suspension hardware
(Not provided) must be rated for a minimum of 180 lbs.
Step 2
Step 3A
Step 3B
To avoid the risk of fire, explosion, or electric shock, this
product should be installed, inspected, and maintained by
a qualified electrician only, in accordance with all applicable
electrical codes.
To reduce the risk of electric shock, disconnect the luminaire
from the supply circuit before opening for installation and
servicing. Keep tightly closed when in operation.
Attention:
Le luminaire XR ne doit pas être orienté vers le haut à un degré
quelconque audelà de la position horizontale pour les installations
en zones dangereuses de classe II, division 2, zone 22 et classe III.
Warning:
The XR head must not face upwards any degree beyond the
horizontal position for Class II, Division 2, Zone 22 and Class III
hazardous location installations.
SPZ-XR
Warning
POTENTIAL ELECTROSTATIC
CHARGING HAZARD
Avoid electrostatic discharge :
•
Clean exterior lens surface with damp cloth only
LIGHT
BEAM
HORIZON
