UK/Europe Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Toll Free: +1 888 505 8335
15
Power Up Functionality
Power Up Functionality :
After power is supplied to the unit :
If no PIN is present the Illuminators will go into Programming Mode for 7 Days and
then will default to Operating Mode
-
During this time if the remote is used to change settings the illuminators will still
default into Operating Mode after 7 Days from the power up (unless the remote
disable button is used to change the illuminator to Operating Mode)
-
During this time if the manual buttons are used in either Illuminator Settings
Modes or Illuminator Configuration Modes the Illuminator will default into
Operating Mode 30 minutes after the last button press
16
Illuminator RESET Options
There are Two Re-set options for resetting the illuminators on your VAR2-VLK2 unit
Settings Re-set :
Pressing and holding the RESET BUTTON in programming mode on the remote control
or using the manual buttons to complete a RESET will restore the factory settings to
the illuminator. Note : If a PIN is present it will not be removed and the illuminator will
return to the mode you were in (Programming or Operating) prior to the re-set . Both
indicator LEDs will flash AMBER when completed.
Full Re-Set :
The other option to reset your illuminator is available by recycling the power whilst
holding down the two manual buttons. This is a FULL RESET and will restore factory
settings AND remove the PIN if one has been set.
Both Indicator LEDs will flash AMBER when completed.
