UK/Europe Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Toll Free: +1 888 505 8335
Photocell Level Mode (LHS LED : Solid GREEN)
RHS LED:
Low sensitivity:
1 Flash GREEN
Medium Sensitivity: 2 Flashes GREEN
High Sensitivity:
3 Flashes GREEN
Disabled photocell: Solid RED
Enable / Disable Status Indicator LEDs Mode (LHS LED: Solid AMBER)
RHS LED:
Enable LEDs: Solid GREEN
Disable LEDS: Solid RED
NOTE – If no buttons are pressed within 2 minutes the Illuminator times out and
returns to the previous mode it was in – either operating or programming mode.
14.4
Illuminator Security Modes Detail :
Enter this mode by a long 4 second press of LHS button to turn LHS LED Flashing RED.
Pressing the LHS button again momentarily will turn the LHS LED Flashing GREEN and
pressing a third time momentarily will turn the LHS LED Flashing AMBER. Each of these
colours indicates which setting mode you are in.
A further momentary press of LHS Button will exit from the mode entry, both LEDs will
go blank for 1 second and then return to the standard indication of either operating
mode or programming mode (depending on which mode the illuminator was in
previously before selecting manual controls)
The following modes are available :
Illuminator Reset Mode (LHS LED : Flashing RED)
RHS LED: Solid RED
Keep RHS BUTTON depressed for 4 seconds. RHS LED stays solid RED and then after 4
seconds both LEDs flash AMBER to show the illuminator has been reset. This operation
is equivalent to the factory reset button on the remote control. It will not re-set a PIN if
one is present.
Remote Control Disable and Enter Operating Mode or Remote Control Enable and
enter Programming Mode (LHS LED : Flashing GREEN)
RHS LED:
Enable Remote: Solid GREEN
Disable Remote: Solid RED
Note : If there is a PIN present and the Illuminator is in Operating mode you cannot
enable the Remote Control and enter Programming Mode
