UK/Europe Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Toll Free: +1 888 505 8335
13
Remote Control Operation for PIN set and Manual Button Disable / Enable
The illuminators have an additional security feature which allows you to protect the settings using a PIN.
A benefit of this for the Vario2 VLK is that If each illuminator is set with a different PIN, the Illuminators
can be adjusted separately from the ground. (For first time installation and PIN setting, cover the base of
one lamp to stop both lamps being set the same). For both lamps to be set the same, ensure both lamps
are in Prog. Mode and are programmed with the same remote control from an acceptable distance.
Action
Required
Available
Mode
Step1
Step 2
LHS
LED
RHS
LED
Comment
Disable
Remote
Prog. Mode
Press <Disable
Remote
Control> for 4
seconds
N/A
Solid Green
Flashing Amber –
Solid Amber - Off
Right Hand flashing
Amber LED will stop
RHS LED will go
Amber when the
button is pressed
and turn off when in
Operating Mode
Disable
Manual
Buttons
Operating
Modes
Press <Disable
Remote
Control> for 4
seconds
N/A
Solid Green –
After 4 seconds
Flashing Red
(Returns to Solid
Green after
button release)
Off – Solid
Amber - After 4
seconds Flashing
Red
(Returns to Solid
Green after
button release)
Must be done
within 5 minutes of
Disabling remote /
entering Operating
Mode. Change will
take effect after 30
minutes
Create or
Change PIN
Prog. Mode
Press <Status
Button> for 4
seconds
Enter valid
PIN
character
x 4
Green –
Intermittent
Flashing Red /
Green - Green
Solid Amber –
Flashing Red
counts down the
No. of valid
characters
required –
Flashing Amber
Stays in
Programming Mode
after PIN created or
changed
Enter
existing PIN
Prog.
Mode
Press <Status
Button> for 4
seconds
Enter valid
PIN
character
x 4
Green –
Intermittent
Flashing Red /
Green - Green
Solid Amber –
Flashing Green
counts down the
No. of characters
required –
Flashing Amber
Enters Programming
Mode after valid PIN
entered
If invalid PIN
entered both LEDs
flash red and unit
will stay in
Operating Mode
Delete PIN
Prog. Mode
Press <Status
Button> for 4
seconds
Press <Re-
Set> button
4 times
Green –
Intermittent
Flashing Red /
Green - Green
Solid Amber –
Flashing Red
counts down the
No. of valid
characters
required –
Flashing Amber
Stays in
Programming Mode
after PIN deleted
Summary Table