UK/Europe Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Toll Free: +1 888 505 8335
The number of button pushes indicated in the table is based on the user starting with the illuminator in
either programming or operating mode.
If the user has already started to program the units, then the number of button pushes on the left hand
will take them to the next function as per the sequence in the table.
If no buttons are pressed within 2 minutes then the illuminator will automatically default back into the
previous mode it was in – programming or operating mode.
The buttons are active in both programming mode and operating mode regardless of
whether a PIN is present or not unless you have previously disabled the manual
buttons
As soon as manual button mode is entered by pressing the Left Hand Button, the
standard LED indicators will be disabled and will indicate a new set of information,
Standard LED indicators are enabled after exiting manual button modes.
Note : Unless detailed as part of the functionality, if an invalid or blocked button push
is attempted, both LEDs will flash Red
14.1
Mode Selection by using LHS Button :
A momentary press of LHS button turn LHS LED solid RED and enters the user into the
Illuminator Settings Modes.
In these modes you can change the following settings :
-
Power Level
-
Photocell sensitivity
-
Indicator LED status (On or Off)
A continuous 4 second press of the LHS button turns LHS LED flashing RED and enters
the user into the Illuminator Security Modes.
In these modes you can change the following Security/Configurations :
-
Illuminator Re-set
-
Disable Remote Control and enter Operating Mode or Enable
Remote Control and enter Programming Mode
-
Manual Button Enable / Disable
*Note – If the status indicator LEDs are disabled and you use the manual buttons the
indicator LEDs will still illuminate accordingly
