Raypak 88AR-398A, Installation & Operating Instructions Manual

Page: 43 / 68

43
Table R: Boiler View Menu
Boiler View Menu
The Boiler View displays various items regarding ignition, temperature monitoring, and modulation rates. As well
as software and hardware information
Item Application Description User
BOILER 1 ALL Enables Boiler for operation
BOILER 2 CASCADE Enables Boiler for cascade operation
BOILER 3 CASCADE Enables Boiler for cascade operation
BOILER 4 CASCADE Enables Boiler for cascade operation
IGNITION ALL
IDLE=no CFH PREP=pre-purge or inter-purge between trials for ignition IGN=trial for
ignition BURN=burner operating POST=post purge HARD=a hard lockout fault has
occurred requiring manual reset (Ignition Lockout or manual high limit) and SOFT=a
soft lockout fault has occurred which interrupts the heating cycle (any safety other
than ignition or manual high limit).
The CFH will resume after the soft lockout fault has been corrected and a 15 min.
waiting period has expired.
N/A
LIMIT TEMP ALL Current Outlet -Limit temperature N/A
EMS Vdc ALL Current EMS signal in Volts DC N/A
FIRE RATE ALL PIM N/A
SPEEDX 1000 ALL Blower speed in revolutions per minute (rpm) x 1000 N/A
OUTLET MAX Mode 1, 2, 3
Defines Max Outlet temperature offset above Target Setpoint (Press and hold up and
down arrows for 3 seconds to enable adjustment), see Versa IC manual, catalog
5000.72.
OPERATOR ALL Operator Potentiometer setting on PIM N/A
DIFF ALL Current auto differential – Fixed by PIM N/A
Pump Post ALL Sets the length of the boiler pump purge N/A
FLAME CUR ALL Flame current in micro-amps (µA) N/A
MASS ALL Thermal mass recovery, see Versa IC manual, catalog 5000.72.
IDENTITY ALL Identifies the unit as boiler, water heater or pool heater N/A
IGN TYPE ALL PIM Board type N/A
ID CARD ALL Identifies Raypak Identity Card N/A
SW ID ALL PIM Software identification number N/A
ERROR CODE ALL Current Error Code N/A