Raymarine Verado, Installation And Commissioning Manual

Page: 45 / 72

SmartPilot Verado Installation and Commissioning Guide 35
• the boat will start a series of zig-zag turns and the display will show LEARNING with a
number to indicate the current AutoLearn stage
• this number will increase as AutoLearn progresses
• typically, the AutoLearn will be complete within 7 to 27 steps (depending on boat
characteristics and sea conditions)
Note:
If you need to cancel the AutoLearn, press the standby or disp key.
5. When the SmartPilot has finished learning, the controller will beep and will display either
LRN PASS or LRN FAIL:
• LRN PASS = AutoLearn completed successfully
• LRN FAIL = AutoLearn was not successful and should be repeated again. A failure
code will also be displayed:
1 = AutoLearn has not been carried out
2 = AutoLearn failed, due to manual interruption
4 = AutoLearn failed, probably due to drive or compass failure
6. Press and hold the standby key for two seconds to store the new settings.
Your SmartPilot is now fully calibrated and ready for use. Please refer to the
SmartPilot Operating Guide for full details.
After 10 hours operation, recheck the hydraulic system for signs of oil leakage.
D8592-1
Start Autolearn
2 sec x2
x4
To prepare for the AutoLearn:
• steer straight ahead at cruising speed
(planing boats – just on the plane)
• head into wind and waves
Check you have
sufficient clear sea space
before proceeding
AutoLearn
in progress
Start the AutoLearn