2-4
Installation
8. Continue to push the bracket onto the transceiver until it is flush with
the front bezel.
9. On each side of the transceiver, insert a screw through the bracket tab
and into the threaded holes from which you removed the yoke knobs.
10. Tighten the screws.
11. It is recommended to run a bead of RTV or similar sealant around the
inside edge of the bracket to avoid water entry behind the console.
12. Insert the radio and attached bracket into the cutout.
13. Install four flat head screws through the four countersunk holes in the
front of the bracket and secure into the console.
14. From behind the console, connect the power/optional speaker and
antenna cables.
Rear Mounting
7. It is recommended to run a bead of RTV or similar sealant around the
inside edge of the bezel to avoid water entry behind the console.
8. Insert the radio into the cutout until the front bezel is flush with the
console.
9. From behind the console, push the flush mount bracket over the rear
of the transceiver such that the tabs on the bracket point away from
the radio’s front bezel.
10. Continue to push the bracket onto the transceiver until it is flush with
the console.
11. On each side of the transceiver, insert a screw through the bracket tab
and into the threaded holes from which you removed the yoke knobs
but do not fully tighten at this time.
12. Install four pan head screws through the four holes in the bracket and
secure the bracket into the console.
13. From the front, make sure the transceiver is still flush with the console.
14. From behind the console, fully tighten the screws that secure the bracket
to the radio’s threaded yoke knob holes.
15. Connect the power/optional speaker and antenna cables.
Summary of Contents for Ray215e
