Note:
The Pole Mount Adaptor may also be used to
rail mount the unit using a 3rd party rail clamp with
a 1 inch 14 TPI thread.
5.3 Surface mounting using
the Deck mounting kit
The Deck mounting kit (A80437) can be used to surface
or bracket mount your product.
The Riser and Bracket pieces are not required for this
installation.
1. Use the Mounting tray template supplied with the
Deck mounting kit to drill 4 holes in the mounting
surface, plus a 22 mm (7/8 in) hole for the
SeaTalkng® cable. Place the small sealing ring in
the groove located on the bottom of the mounting
tray.
2. Secure the tray to the mounting surface using the
supplied fixings.
3. Place the large sealing ring into the groove on the
upper side of the mounting tray.
4. Pull the SeaTalkng® cable through the mounting
surface hole and the mounting tray. Plug in the cable
connector on the underside of the unit and secure
by rotating the locking collar clockwise 2 clicks.
5. Secure the unit to the Mounting tray by positioning
the unit with the LED facing forward and inserting
the unit into the grooves in the Mounting tray.
6. Place the Mounting trim over the unit slightly offset,
and then twist the Mounting trim clockwise until it
locks into position.
27
