i.
Press any button on a display that has ‘
JOIN
’
flashing onscreen.
The Display will show ‘
JOIN YES
’
ii. Confirm by pressing any button on the same
display.
The display will show ‘
DONE
’.
If confirmation is not completed within 25 seconds,
‘FAIL’ will be shown which means the display has
not joined the network.
When the countdown is complete, the chosen
display returns to the Autonetworking page. Press
and hold the
Set up
button for 2 seconds to
return to normal operation.
11. Test the system:
i.
Switch off the chosen display.
ii. Switch on the chosen display.
If some units do not power up, check that all new
units are within 300 mm (11.8 in) of the chosen
display and if required, are connected to a power
source.
12. Repeat the steps above until all units have joined
the network.
13. If you are replacing older units, remove them from
the vessel.
14. Ensure all units are working correctly before
mounting them.
Product identification on Micronet
The Micro-Talk gateway is identified differently during
the Autonetworking process than when checking the
Health pages from a Micronet display.
During Autonetworking the gateway is identified as an
NMEA 2000 device (i.e.:
2000
,
N2000
, or
N 2000
)
When checking the Health pages from a Micronet
display the gateway is identified as Type 7 device (i.e:
TYP7
,
TYPE7
or
TYPE 7
.
24
