5.1 Surface mounting
The unit can be mounted on a surface that is up to approximately 28 mm (1.10 in) thick using the
fixings supplied with the unit. To mount on a thicker surface longer studs will be required.
Ensure that the chosen location meets the product’s location requirements, see
for details.
1. Affix the supplied mounting template to the mounting surface at the desired location.
2. Drill 3 x fixing holes and 1 x cable hole using drill bit sizes as indicated on the template.
3. Place the waterproof gasket into position on the underside of the unit.
4. Connect the cable to an available
SeaTalk
ng
spur connection then connect the other end to the
connector on the underside of the unit and secure using the locking collar.
5. Screw the threaded studs into the underside of the unit (these should be hand-tight only).
6. Position the unit so that the mounting studs pass through the holes in the mounting surface.
7. Secure the unit to the mounting surface using the thumb nuts. (these should be hand-tight only).
44
