3.6 Selecting a location
Warning: Potential ignition source
This product is NOT approved for use in hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable atmosphere (such as in an engine room
or near fuel tanks).
Micronet device location requirements
Your unit includes a wireless transceiver that utilizes the Micronet networking protocol. The product’s
wireless performance should be checked at the desired location before drilling any mounting holes.
For optimum performance, the product should be installed above decks, on a horizontal surface with
the LED ‘arrow’ pointing towards the bow or the stern of the vessel.
When planning the installation location, also consider the following:
• The unit should have a clear line of sight to the Micronet products it will connect to. The range for
unobstructed line of sight is up to 150 m (492 ft), if the line of sight is obstructed by a bulkhead or
other objects this range can be drastically reduced.
• The unit should be mounted at least 1 m (3 ft) away from devices that may cause interference, such
as a compass, motors, generators, VHF radio, and any other transmitters or receivers.
• Choose a location where the unit will be safe from physical damage and excessive vibration.
• Choose a location where no load or force maybe put on the unit.
• Mount away from any source of heat or potential flammable hazards, such as fuel vapor.
• The unit should be mounted in a location where the diagnostics LED is viewable.
27
