Chapter 1: Important information
Certified Installation
Raymarine recommends certified installation by a
Raymarine approved installer. A certified installation
qualifies for enhanced product warranty benefits.
Contact your Raymarine dealer for further details,
and refer to the separate warranty document packed
with your product.
Warning: Product installation and
operation
This product must be installed and
operated in accordance with the
instructions provided. Failure to do so
could result in personal injury, damage
to your vessel and/or poor product
performance.
Warning: Potential ignition source
This product is NOT approved for use in
hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable
atmosphere (such as in an engine room
or near fuel tanks).
Warning: Positive ground systems
Do not connect this unit to a system which
has positive grounding.
Caution: Power supply protection
When installing this product ensure the
power source is adequately protected
by means of a suitably-rated fuse or
automatic circuit breaker.
Warning: Switch off power supply
Ensure the vessel’s power supply is
switched OFF before starting to install this
product. Do NOT connect or disconnect
equipment with the power switched on,
unless instructed in this document.
Warning: High voltage
This product contains high voltage.
Adjustments require specialized service
procedures and tools only available to
qualified service technicians. There are
no user serviceable parts or adjustments.
The operator should never remove the
cover or attempt to service the product.
Caution: Transducer cable
• Do NOT cut, shorten, or splice the
transducer cable.
• Do NOT remove the connector.
If the cable is cut, it cannot be repaired.
Cutting the cable will also void the
warranty.
Caution: Service and maintenance
This product contains no user serviceable
components. Please refer all maintenance
and repair to authorized Raymarine
dealers. Unauthorized repair may affect
your warranty.
Water ingress
Water ingress disclaimer
Although the waterproof rating capacity of this
product meets the stated IPX standard (refer to the
product’s
Technical Specification
), water intrusion
and subsequent equipment failure may occur if the
product is subjected to commercial high-pressure
washing. Raymarine will not warrant products
subjected to high-pressure washing.
Disclaimer
Raymarine does not warrant that this product is
error-free or that it is compatible with products
manufactured by any person or entity other than
Raymarine.
Raymarine is not responsible for damages or injuries
caused by your use or inability to use the product,
by the interaction of the product with products
manufactured by others, or by errors in information
utilized by the product supplied by third parties.
EMC installation guidelines
Raymarine equipment and accessories conform to
the appropriate Electromagnetic Compatibility (EMC)
regulations, to minimize electromagnetic interference
between equipment and minimize the effect such
interference could have on the performance of your
system
Correct installation is required to ensure that EMC
performance is not compromised.
Note:
In areas of extreme EMC interference,
some slight interference may be noticed on the
product. Where this occurs the product and the
source of the interference should be separated by
a greater distance.
For
optimum
EMC performance we recommend
that wherever possible:
• Raymarine equipment and cables connected to
it are:
Important information
7
Summary of Contents for i60 ch wind
