Raymarine i60 ch wind, Installation And Operation Instructions Manual

Page: 26 / 70

4.4 Transducer connections
Transducer connections only apply to the i60 Wind
instrument, the i60 Close hauled wind does not
include transducer connections as it is a repeater
display.
i60 transducer connections
6
7
3
4
5
D12396-1
1
2
1 Blue Rotor +
(Rotavecta)
2 Red Rotor –
(Rotavecta)
3 Grey Wind 0 V (Shield)
4 Yellow Anemometer
(signal)
5
Blue Cosine wind
direction
6 Green Sine wind direction
7
Red Wind V+
Note: Connectors 1 and 2 are rotavecta
connections, connectors 3 to 7 are for wind
transducers.
Making transducer connections
Although the transducer cable is fitted with spade
connectors for direct connection to the rear of the
unit, it may be necessary to remove these to facilitate
installation, e.g. if the cable has to be routed through
narrow apertures. 1/8th spade terminals will be
required (not supplied), to replace those removed.
When fitting the new spade connectors, prepare the
cables as detailed below:
3 mm
6 mm
50 mm
1
2
D12359-1
1. Prepare the cable as shown in 1 above.
2. Fold back the wire strands and insert into the new
spade connector as shown in 2 above.
3. Ensure the wire strands do not extend beyond
the rear of the spade connector insulation.
4. Crimp the connector to the wire.
4.5 iTC-5 connection
Transducers can be connected to a SeaTalk ng
network using Raymarine's Instrument transducer
converter (iTC-5) and an i70 instrument, the data
can then be repeated on an i50 / i60 unit.
12 V
D12033-3
1 2 3 4
5
6 7 8
1 i50 Depth (Repeater)
2 i70 Instrument (Master)
3 i50 Speed (Repeater)
4 i60 Wind (Repeater)
5 iTC-5
6 Depth transducer
7 Wind vane transducer
8 Speed transducer
Note: Transducers connected to the iTC-5 must be
calibrated using an i70 (master) unit. Transducers
connected to the iTC-5 cannot be calibrated using
an i50 / i60.
Making iTC-5 transducer connections
For instructions on connecting transducers to your
iTC-5 refer to the iTC-5 handbook.
26 i60