Raymarine i60 ch wind, Installation And Operation Instructions Manual

Page: 30 / 70

5.1 Mounting
Pre-mounting check
The product is designed to be surface mounted.
Before mounting the unit, ensure you have:
• Selected a suitable location.
• Identified the cable connections and route that the
cables will take.
• Detached the front bezel.
• Remove the keypad mat.
Mounting diagram
D12379-1
Mounting instructions
1. Check the selected location for the unit, a clear,
flat area with suitable clearance behind the panel
is required.
2. Fix the mounting template supplied with the
product, to the selected location, using masking
or self adhesive tape.
3. If possible use an appropriate size hole cutting
saw and cut out the centre hole cut out area as
indicated on the mounting template, or
4. Using a suitable hole cutting saw, make pilot
holes in each corner of the cut out area and using
a jigsaw cut along the inside edge of the cut out
line.
5. Ensure that the unit fits into the removed area
and then file around the cut edge until smooth.
6. Drill any required holes as indicated on the
mounting template for the securing screws.
7. Connect the relevant cables to the unit.
8. Peel the backing off of the supplied gasket and
place the adhesive side of the gasket onto the
display unit and press firmly onto the flange.
9. Slide the unit into place and secure using the
screws provided.
10. Refit keypad mat and front bezel.
Note: Drill, tap size and tightening torques are
dependant upon the material type and thickness
of the mounting surface.
Note: The supplied gasket provides a seal
between the unit and a suitably flat and stiff
mounting surface or binnacle. The gasket should
be used in all installations. It may also be
necessary to use a marine-grade sealant if the
mounting surface or binnacle is not entirely flat and
stiff or has a rough surface finish.
30 i60