Raymarine i60 ch wind, Installation And Operation Instructions Manual

Page: 46 / 70

8.3 Illumination
Adjusting the backlight level
The backlighting can be adjusted using the power
button.
Display
1 0
15
20
25
30
35
40
45
50
55
60 5
1
V MG
T a ck
D13143-1
During normal operation:
1. Press and hold the
Display button for
approximately 1 second until the backlight page
is displayed.
L
and the current illumination level is displayed.
2. Use the VMG button to decrease the illumination
level.
3. Use the Tack button to increase the illumination
level.
The illumination level can be adjusted from
0 (default)
(Off) to
9
(Max)
Note: The backlight page will time-out after 8
seconds of inactivity.
Adjusting the contrast — i60
The contrast level can be accessed using the Speed
button.
During normal operation:
1. Press and hold the
Display button for
approximately 4 seconds to display the Contrast
page.
C
is displayed on-screen and the current contrast
level.
2. Use the Display button to cycle through the
available contrast levels.
The contrast level can be adjusted from level
0 (default) to 3.
Note: The contrast page will time-out after 8
seconds of inactivity.
Group illumination
Group illumination is used to synchronizes and
control the backlighting level of multiple units
assigned to the same group.
The unit can participate in shared illumination
via a SeaTalk network or group illumination via a
SeaTalk
ng network.
When connected on a SeaTalk network all
compatible units will share their backlight level (when
1 unit's backlighting level is adjusted all other units
backlight level will also change).
When connected on a SeaTalk ng network the unit
can participate in group illumination and be assigned
to a group of units which will share their backlighting
levels. Available groups are as follows:
•
OFF (default)
— Group illumination is
switched off
•
HL1
— Helm 1
•
HL2
— Helm 2
•
CPt
— Cockpit
•
FLY
— Flybridge
•
NST
— Mast
•
GP1
to
GP5
— User defined groups
When assigned to a group, when the backlighting of
1 unit is adjusted the backlighting level of all units
assigned to the same group will also change.
Assigning the unit to a group
To assign the unit as part of a group so that it can
participate in group illumination follow the steps
below.
During normal operation:
1. Press and hold the
Display and True / App
buttons a the same time for approximately 6
seconds, until the Group Illumination page is
displayed.
GrP
is displayed on-screen
Note: The Group Illumination page is a temporary
page and will time-out to the previous page after
8 seconds.
2. Press the Display button to display the current
group illumination setting.
3. Press the VMG and Tack buttons at the same
time to change the current setting.
The current group setting will flash.
4. Use the Tack button to cycle upwards through
the list of available groups.
5. Use the VMG button to cycle back down through
the list.
6. Press the VMG and Tack buttons at the same
time to assign the display to the selected group.
The group setting will stop flashing.
7. Press and hold the Display and True / App
buttons a the same time for approximately 2
seconds to return to normal operation.
46 i60