Raymarine HSB Chartplotter, User Manual

Page: 109 / 154

92 HSB Series Chartplotter
Object Information
You can set Object Information ON or OFF. When set ON, object
information is displayed in normal chartplotter operation when the cursor
is placed over a chart object for two seconds. When set OFF, no
information is displayed.
Waypoint Options
Waypoint controls whether or not the waypoints are shown on the Chart
display, with their appropriate symbols. The active waypoint, and
waypoints in the current route are always shown.
Waypoint Numbers controls whether or not the waypoint numbers are
shown for any waypoints in the current route.
Default Waypoint Symbol lets you select the symbol you want used for
waypoint display.
Vectors
Heading, Tide and Course Over Ground vectors can be displayed as a
line from your vessel. The length of the vector is determined by your
choice of SOG and the time period. An infinite vector extends to the
edge of the chart screen.
Heading Vector indicates your current heading.
COG Vector indicates your course over ground.
Tide Vector indicates the tide angle. Tide information is calculated from
the speed through water, compass and position data.
Datum Selection
You can select either WGS 84 or LOCAL datum. In LOCAL mode, you
are presented with a list of datums; use the trackpad to scroll through the
list, then press ENTER to select the option and close the menu.
When you change datum selection, the system attempts to set any
connected GPS to the new mode, using SeaTalk and NMEA set up
commands. A message shows whether the set up was successful or
not.
Chart
Set Up
Parameters