Raymarine G-Series system, Installation & Commissioning Instructions

Page: 93 / 128

93 Chapter 9: Troubleshooting
Keyboards
• The keyboard does not operate monitor setting
menus.
• On or more monitors are not listed when config-
uring the monitors or Nav Stations.
• SeaTalk
hs
network problem • Check the status of the SeaTalk
hs
Switch.
Refer to troubleshooting SeaTalk
hs
Switch LED indica-
tions on page 98
• Check the marine monitor and ensure that the network
selector switch is in the “up” position (required when
connected to the SeaTalk
hs
network).
• Check that the monitor and GPM400 are both connected
to the SeaTalk
hs
switch.
• Check that SeaTalk
hs
cables are free from damage.
• The monitor is not a Raymarine G-Series unit. • Only G-Series marine monitors are compatible with the
SeaTalk
hs
network required for this functionality.
• Software mismatch between equipment may
prevent communication.
• Contact Raymarine technical support
Problem Possible causes Possible solutions
Problem Possible causes Possible solutions
• Keyboard LCD is blank.
• (Monitor may also show no keyboards
connected message)
• The Keyboard is not connected to SeaTalk
ng
or
has no power.
• Check keyboard wiring and power to SeaTalk
ng
bus.
• Wireless keyboard is not charged up. • Connect wireless keyboard to charge point.
Keyboard LCD shows low battery • Wireless keyboard battery requires charging
• Degraded / old keyboard battery requires
replacing
• Charge keyboard battery at appropriate charge point.
• Replace battery
• Keyboard LCD shows sw version message.
e.g 86/78 F64D V0.6A
• (Monitor may also show no keyboards
connected message)
• The Keyboard cannot communicate with a
GPM400 processor
• Ensure GPM400 processors are connected to the
SeaTalk
ng
system.
• Wireless basestation is not operating or is
disconnected from SeaTalk
ng
.
• Check power and connections to SeaTalk
ng
wireless
basestation.
• Wireless basestation is out of range • Re-survey wireless coverage and move / add repeat
basestations if necessary.