Raymarine G-Series system, Installation & Commissioning Instructions

Page: 65 / 128

65 Chapter 5: Installation and mounting
Mounting and environment
The following conditions apply:
• You must perform a site survey to find an appropriate location
and ensure good wireless reception around the boat.
• Do NOT install near sources of heat or vibration. (e.g. engine).
• Install in a dry area as high on the vessel as possible.
• Mount on a vertical surface.
• Install the unit well away from potential sources of ignition.
• Mount at least 1 m (3 ft) away from devices which may be af-
fected by radio transmission (e.g. compass)
Site survey (wireless coverage)
You will need to survey the wireless coverage to ensure that wire-
less devices can operate around the vessel.
Repeat basestation
A repeat basestation may be used to optimize wireless coverage.
Note: Only the master basestation is connected to SeaTalk
ng
. The
repeat basestation requires a power connection only.
5.4 G-Series Monitors
To install your monitor refer to the separate instructions provided.
See also
Ensure you record your monitor details on the schematic diagram.
See
Appendix B - Nav Station schematic .
Fit Base Station as high up as possible, in a dry location
D10205-1
Note: Only the master basestation is connected to SeaTalk
ng
.
The repeat basestation requires a power connection only.
D10207-1