![background image](http://html.mh-extra.com/html/raylase/sp-ice-1-pci-e-pro/sp-ice-1-pci-e-pro_hardware-manual_789722011.webp)
Chapter 2
Technical Data
11
RAYLASE SP-ICE-1 PCI/e PRO Control Cards
2.4.4
Port C, Laser / I/O Interface
The interface provides analogous signals to control laser power, and digital signals to control
laser devices such as a laser modulation driver. Further digital signals can be used for syn-
chronizing marking with external controllers – for instance a foot switch or a PLC.
FPS = first pulse suppression, LM = laser modulation, MIP = mark in progress
Please note:
/START_MARK and /STOP_MARK are read simultaneously with the laser interface
(
page 13). After the input buffer, the signals will be merged with an OR function.
Adaption of Outputs
FPS = first pulse suppression, LM = laser modulation, MIP = mark in progress
Analog Output
The analog output is dedicated to control the diode or lamp current of an Nd:YAG laser. The
output voltage range can be adjusted via software (commands Write_DA and Write_DA_List).
Specifications
J2
PIN Signal
PIN Signal
9 PIN D-
SUB
1
TTL hc Output
LM or /LM
6
VDD Out
+5V
2
TTL hc Output
LM_GATE or /LM_GATE
7
TTL Output
/MIP or GND
3
TTL hc Output
FPS or /FPS
8
TTL
INPUT24V
/START_MARK
4
Analog
Output 1
ANA_OUT
9
TTL
INPUT24V
/STOP_MARK
5
GND
Analog & Digital Return
-
---
---
W4 to W8
ID
Jumper at the left
Jumper at the right
Standard configuration
W5
/FPS
FPS
W8
GND
/MIP
W6
/LM_GATE
LM_GATE
W7
GND
5V
W4
/LM
LM
TTL Input24V
TTL Outputs
Input low
max. 1.3V
TTL low
0.5V max.
max. 4mA
Input high
1.6V to 24.0V
TTL high
3.84V to 5.0V
max. 4mA
Hysteresis
typ. 1.1V
Input impedance
approx. 3k
Ω
ESD protection
± 10 kV
Analog output
TTL hc Outputs
Amplitude
0V to +10V ± 1%
TTL low
max. 0,5V
max. 40mA
Output current
5mA max.
TTL high
min 2V
max. 40mA
Bandwidth
1kHz
DAC resolution
16Bit
Noise ratio (
1 GHz)
60dB min.