![background image](http://html.mh-extra.com/html/raylase/sp-ice-1-pci-e-pro/sp-ice-1-pci-e-pro_hardware-manual_789722019.webp)
Chapter 4
Installation
19
RAYLASE SP-ICE-1 PCI/e PRO Control Cards
4.2.3
Master-Master Mode
To install the SP-ICE-1 PCI/e PRO control cards in the PC for master-master mode, proceed
as follows:
Driver Installation (Windows® XP/ Windows
®
Vista/ Windows
®
7)
First install the drivers. Please note the description for installing the SP-ICE-1 PCI/e PRO
software delivered on the installation CD.
Installation of the first SP-ICE-1 PCI/e PRO Control Card
᪻
Switch off the PC.
᪻
Disconnect the PC from the mains supply outlet.
᪻
Open the housing of the PC.
᪻
Plug the first SP-ICE-1 PCI/e PRO control card in a free PCI slot/PCIe slot and fasten the
board with screw. Please be aware, that all other SP-ICE-1 PCI/e PRO control cards will be
installed later on.
᪻
Close the housing of the PC.
᪻
When booting the PC the SP-ICE-1 PCI/e PRO control card is detected and set up auto-
matically.
Installation of further SP-ICE-1 PCI/e PRO Control Cards
The following procedure has to be performed for any further SP-ICE-1 PCI/e PRO control card,
i.e. up to three times.
᪻
Shut down the operating system and switch off the PC.
᪻
Disconnect the PC from the mains supply outlet and open the housing of the PC.
᪻
Insert a further SP-ICE-1 PCI/e PRO control card and proceed as described in section
“Installation of the first SP-ICE-1 PCI/e PRO control card” (see above).
᪻
Restart the PC. The second (and all other) SP-ICE-1 PCI/e PRO control cards are detected
and set up automatically.
Completion of installation
After all SP-ICE-1 PCI/e PRO control cards are installed properly, start the „SP-ICE Config“
program via Start
Programs
RAYLASE
Tools („SpiceCfg.exe“ program located in
\programme\raylase\sp-ice\bin) and select the total numbers of SP-ICE-1 PCI/e PRO control
cards installed.
4.2.4
Stand-Alone Mode
For stand-alone operation please contact the RAYLASE staff (
Fig. 6
Master-Master-
Modus