RaycoWylie i4507, Instruction Manual

Page: 66 / 78

55M4507OBE00-B
66
i4507 Offshore Lattice Boom Crane
Instruction Manual
5.7.1 Internal Peripherals (Cont’d)
Error Message Execution Process Cause of Error
• Canbus 1 is defective, or
Canbus 2 is defective.
The CANBus controller
verification There is a problem with
the CANbus controller on the
Mother Board,
Not calibrated No calibration has been
found for the selected duty. 1) Verify if the load chart
corresponding to the crane
has been calibrated.
2) Does the load chart depend
on rotation?
3) Does the load chart depend
on DIN inputs ?
No 2nd duty found
The load chart must be
programmed in order to
compare two charts. One of
them is based on the angle
and the other one is based
on the radius. The smallest
value will be selected.
The Angle/Radius option
must be activated during the
compilation of the load chart
No Parameter The crane dimensions must
be correctly entered in the
system otherwise the load
value will be non existant or
wrong.
CL3 , CL4 and CL7 values
should never be at zero.