RCMDC-6627-PF-48
INSTALL INSTRUCTIONS
www.raycap.com
©Raycap • All rights reserved
320-1204 Rev.E
Page 30 of 38
A.1
Copyright
©
Raycap, Inc. 2018 - All Rights Reserved
A.1.1
Disclaimer
The information in this document is subject to change without notice and describes only the product
defined in the introduction of this documentation. This documentation is intended for the use of
Raycap customers only for the purposes of the agreement under which the document is submitted,
and no part may be used, reproduced, modified or transmitted in any form or means without the prior
written permission of Raycap. The documentation has been prepared to be used by professional
and properly trained personnel, and the customer assumes full responsibility when using it. Raycap
welcomes customer comments as part of the process of continuous development and improvement
of the documentation.
Raycap has made all reasonable efforts to ensure that the instructions contained in this document
are adequate and free of material errors and omissions. Raycap will, if deemed necessary, explain
issues which may not be covered by this document.
The contents of this document are subject to revision without notice due to continued progress in
methodology, design and manufacturing. Raycap shall have no liability for any error damage of any
kind resulting from the use of this document.
A.1.2
Prerequisites
This document describes how to install the High Power Wire Bridge Kit on-site and how to mount,
and connect it to external interfaces.
Installers of Raycap’s RRH surge protective and fiber/power management solutions must be industry
professionals who have attended training on the proper installation of the equipment by Raycap
and/or the mobile operator. Installers are required to read this installation guide thoroughly prior to
installation of the Raycap RRH protection equipment.
Installers shall obey all general and regional installation and safety regulations related to work on
high voltage installations, as well as regulations covering correct use of tools and personal protective
equipment. Use this equipment only for the purpose specified by the manufacturer. Do not carry out
any modifications or fit any parts that are not recommended by the manufacturer. This could cause
electric shock or other injuries.
A.1.3
Tools
7/16
"
Socket
1/2
"
Nut driver or deep socket driver
4mm Hex driver or flat blade screwdriver
A.1.4
Parts in Kit
1x -48 Long Jumper Wire
1x RTN Long Jumper Wire
4x Custom Lug Set Screw
5x Kep Nut (1/4-20) (includes 1 extra)
4x Insulated Caps
For conditions other than those described above, please contact a Raycap Account Representative
at (208) 777-1166, (800) 890-2569 or www.raycap.com
Thank you for choosing quality products from Raycap.
