15
a)
Depressing momentarily
steps the display from C-Sd to C-FC.
b)
Depressing momentarily
steps the display from C-FC to C-Sd.
6)
Selecting C-Sd or C-FC.
a)
To select C-Sd or C-FC, step
until desired code is displayed.
b)
Momentarily depress
, the display will now show "0".
7)
DEFINITION OF BOOM CALIBRATION KEYS.
Depressing this key displays selected boom number in DATA display.
EXAMPLE:
Boom 1 will be displayed as b-01.
Depressing this key after selecting BOOM CAL changes the boom number.
EXAMPLE:
b-01 will change to b-02.
Depressing this key after selecting BOOM CAL changes the boom number.
EXAMPLE:
b-02 will change to b-01.
Enter Boom Data:
a)
Select boom b-01.
b)
Use boom width as calculated under "CALCULATING BOOM CAL".
c)
If a boom is not needed, enter a "0" for the length.
8)
Enter SPEED CAL as calculated under "CALCULATING SPEED CAL" in
.
9)
Enter METER CAL calibration number in
.
10)
A VALVE CAL calibration number is automatically entered into the console based
on what your valve selection was during the initial Console programming settings
(C-Sd=2123 and C-FC=743). To change the VALVE CAL setting, depress
for
5 seconds. The display will show the current VALVE CAL calibration number. Enter
a new VALVE CAL calibration number if desired.
11)
Enter the FLOW RATE target application rate in GPA [lit/ha]{GPK} in
.
NOTE:
A decimal point is displayed automatically. Therefore, twenty gallons
per acre is entered as 20.0, not 2.0.
