16
YOU HAVE NOW COMPLETED PROGRAMMING THE CONSOLE
The display of "CAL" will now extinguish and the Console will begin to display
data. If not, repeat procedure starting at Step 7.
2.
OTHER DISPLAY FEATURES
See Appendix 9 for detailed outline of each Console key and what features are
located under them.
1)
To display the set operating modes for units of measure (US, SI, TU), speed sensor
type (SP1, SP2), and valve type (C-Sd, C-FC)
a)
Depress
for 5 seconds and continue holding. DATA display will toggle
thru selections until key is released.
2)
To display TOTAL AREA covered
a)
Depress
.
b)
To "zero out" this total at any time, enter a "0" in
.
3)
To display TOTAL VOLUME sprayed
a)
Depress
.
b)
To "zero out" this total at any time, enter a "0" in
.
4)
To display speed in MPH [km/h]
a)
Depress
.
5)
To display DISTANCE in feet [m] traveled
a)
Depress
.
b)
To "zero out" this total at any time, enter a "0" in
.
6)
To display actual application flow rate in GAL/MIN [li/min]
a)
Place MASTER switch in ON position
b)
Depress
.
7)
To display target application flow rate
a)
Place MASTER switch to OFF
